FAQ | General and scientific calculators
Category : Scientific calculator features and usage Other
The calculator shows the results as a fraction.
1.
After the result of the operation is shown press the [ S<=>D ] button (below picture). It changes the fraction to decimal number. Using this button you can change between the decimal number form and fraction form.
2. After entering the operation press the [ SHIFT ] button followed by [ = ] instead of [ = ] button.
3. Change the calculator mode from "MathIO" to "LineIO" by pressing the buttons [ SHIFT ] followed by [ MODE ] and then the number [ 2 ] for "LineIO". In "LineIO" Mode the result of a opeation is always shown as a decimal number.
Note: If you enter π or a multiplicator of it and press the [ = ] button the result would be again π or a multiplicator of it. With the help of above mentioned steps you can change the result to a decimal value.
2. After entering the operation press the [ SHIFT ] button followed by [ = ] instead of [ = ] button.
3. Change the calculator mode from "MathIO" to "LineIO" by pressing the buttons [ SHIFT ] followed by [ MODE ] and then the number [ 2 ] for "LineIO". In "LineIO" Mode the result of a opeation is always shown as a decimal number.
Note: If you enter π or a multiplicator of it and press the [ = ] button the result would be again π or a multiplicator of it. With the help of above mentioned steps you can change the result to a decimal value.
