Skip to content

Personal Menu

Personal Menu

Added to Favorites

FAQ | DIMENSION SHIFTER

Features & Usage

Usage & Performance

During performance, could the transmitter extend/retract unintentionally, causing unwanted effect changes?

Both the transmitter and receiver have hold switches (same function). You can switch with one touch so it won't respond even when pulled. Alternatively, by performing calibration, you can set it so it won't respond to slight pulling.

Do I need to pull the transmitter a lot for it to respond? Won't this interfere with performance?

By performing calibration, you can set it to output maximum signal with just a slight pull.

What kind of effect control is possible?

It depends on the specifications of the effects pedal connected to the receiver. Please refer to your effects pedal's instruction manual to see what can be controlled via the expression terminal or external footswitch terminal.

Do I need to perform calibration every time I power on?

Calibration results are retained even after powering off.

Do I need to perform pairing every time I power on?

The previous pairing is retained at startup.

Can the product be used overseas?

It can be used in the United States and Japan. However, use in other countries may violate radio-related regulations in those countries, and we cannot assume any responsibility.

Can it be used outdoors?

This product is not waterproof or water-resistant. Please use it indoors only.

How do the transmitter's minimum and maximum positions correspond to heel and toe positions on a standard expression pedal?

By default, the minimum position corresponds to heel position, and maximum position corresponds to toe position. This correspondence can be reversed by short-pressing the transmitter's reverse/pairing button or setting the receiver's polarity switch to INV side.

Select a location

View all available locations

閉じる