FAQ | Label Printers, Disc Title Printer and Stamp Maker
Category : Troubleshooting Print
Printing is unclear.
A dirty print head or rubber roller will make proper label printing impossible.Perform the procedure below to clean the print head and the rubber roller as required.
1. Press the printer’s ON/Stand-by key to turn off power.
2. Set the printer down on its side, press on the area on the side marked “PUSH” and raise the cover.
3. Remove the cover.
4. If a tape cartridge is loaded in the printer, remove it.
· The print head is hot during and immediately after printing, so wait until it is cooled down before removing the tape cartridge.
5. Use a cotton swab moistened with alcohol to wipe the surfaces of the print head and rubber roller.Focus your wiping in the brown area (bounded by the dotted lines in the illustration) where the print head contacts the rubber roller.
1. Press the printer’s ON/Stand-by key to turn off power.
2. Set the printer down on its side, press on the area on the side marked “PUSH” and raise the cover.
3. Remove the cover.
4. If a tape cartridge is loaded in the printer, remove it.
· The print head is hot during and immediately after printing, so wait until it is cooled down before removing the tape cartridge.
5. Use a cotton swab moistened with alcohol to wipe the surfaces of the print head and rubber roller.Focus your wiping in the brown area (bounded by the dotted lines in the illustration) where the print head contacts the rubber roller.
